The Siemens motor and, above, the Hoyer motor ready for dispatch following repair. These two motors – a 37kW Hoyer and a 40kW Siemens, used for driving pumps – were sent to us from a firm in the petro-chemicals industry. After careful assessment, they were mechanically refurbished by engineers in our Huddersfield service centre. As part of this comprehensive process: Stator windings were washed and stoved before being spray varnished. Bearings and shaft seals showing signs of

Apprentice engineer Callum refits a fan motor on to its housing following a repair. It was one of two fans from a hospital that arrived for inspection in our service centre. Each was stripped down and the state of the windings carefully assessed. New bearings were fitted and the motor was then repainted ready for dispatch. Our engineers offer a variety of fan services including refurbishment, balancing, upgrades and replacements. We also supply a variety of products. So plea

This water cannon, sent to us by a fire equipment company, is intended to send spray into waste recycling pits in case of fire. It is in the Westin Drives service centre to enable our technical engineers to program the control panel, below, to influence the precise direction and flow of the four jets on the cannon.

We recently carried out a comprehensive overhaul on this 68kW ABB induction generator from an Endurance E3120 wind turbine. These...

This Lenze panel was custom-built for a client in the water treatment industry, with detailed specification requirements, such as wiring...

Here’s a great example of the full refurbishment service we carried out for one of our clients.

This week thanks to West Yorkshire Manufacturing Services we were invited to take part in a roundtable discussion with AUKUS Forum at the The University of Huddersfield, alongside fellow companies from local industry.

We offer a comprehensive engineering and maintenance service all under one roof, so if you have time critical electro-mechanical repair requirements, get in touch.

Adam's interview We're proud to share a interview given by our technical services manager, Adam Daffern, to Unifrog. This is an inspiring...

Completed motor Our stock of WEG equipment allows us to respond quickly to customers' needs. Here's an example of an 22kW motor upgrade...

UK guests at the new WEG factory in Santo Tirso, Portugal Our Operations Director, Fraser Lynch, enjoyed a visit to WEG's new...

A customer required sensors and encoders retrofitting to four new pump sets, the sort of challenge on which our engineers thrive. The...

Our team took on a time-sensitive project, one part of which was removal, servicing and a reinstallation of a two-tonne, 250kW electric...

Our technical team has been supporting a customer in the polyurethane foam industry by updating the company's drive systems with Lenze...

'Our company has to give recognition to Westin Drives for their help to get our Hartford VMC coolant system up and running this week....

A component manufacturer in the South of England approached us with a particular request for four geared motors. The requirements: 460V...

A customer stipulated the use of specialised non-flaking paint – suitable for food production environments – on an electric motor and...

Our engineers have repaired many Demag motors, the sort commonly found on overhead cranes. Their conical stator and rotor cores make them...

Members of the Westin Drives technical team taking part in a drives and soft-starters service training session. It was provided by WEG,...

This 250kW compressor motor suffered a severe drive end bearing failure. The end shield was damaged rendering it unrepairable. Thanks to...